Elta LE100 Spezifikationen PDF herunterladen (Seite 27)

Chapter 2 – Hardware Resources

20 PL 3120/PL 3150/PL 3170 Power Line Smart Transceiver Data Boo

Table 2.7 External Memory Interface Pins

Designation

Direction Function

A0 - A15 Output Address Pins

D0 - D7 Input/Output Data Pins

E Output Enable Clock

R/W output Read/Write Select Low

The PL Smart Transceiver can be interfaced to another MPU through the 12 I/O pins using a serial or parallel

connection, or through a dual-ported RAM device such as the Cypress CY7C144, CY7C138, or CY7C1342. There are

pre-defined serial and parallel I/O models for this purpose which are easily implemented. Use the Neuron C

programming language, ShortStack firmware, or MIP firmware to simplify the interface. For more details of dual-ported

RAM interfacing, see Appendix B of the L

ONWORKS Microprocessor Interface Program User’s Guide (Echelon 078-

0017-01).

Input/Output

Twelve Bidirectional I/O Pins

These pins are usable in several different configurations to provide flexible interfacing to external hardware and access

to the internal timer/counters. The logic level of the output pins can be read back by the application processor.

Pins IO4 – IO7 and IO11 have programmable pull-up current sources. They are enabled or disabled with a compiler

directive (see the Neuron C Reference Guide). Pins IO0 – IO3 have high current sink capability (20 mA @ 0.8 V). The

others have sink capability of 1.4 mA @ 0.5 V. All pins (IO0 – IO11) have TTL level inputs with hysteresis. Pins IO0 –

IO7 also have low level detect latches.

Two 16-Bit Timer/Counters

The timer/counters are implemented as a load register writable by the processor, a 16-bit counter, and a latch readable

by the processor. The 16-bit registers are accessed 1 byte at a time. The PL Smart Transceivers have one timer/counter

whose input is selectable among pins IO4 – IO7, and whose output is pin IO0, and a second timer/counter with input

from pin IO4 and output to pin IO1 (Figure 2.7). No I/O pins are dedicated to timer/counter functions. If, for example,

Timer/Counter 1 is used for input signals only, then IO0 is available for other input or output functions. Timer/counter

clock and enable inputs can be from external pins, or from scaled clocks derived from the system clock; the clock rates

of the two timer/counters are independent of each other. External clock actions occur optionally on the rising edge, the

falling edge, or both rising and falling edges of the input.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 253 254

Keine Kommentare

Elta LE100 Spezifikationen Seite 27